Paints and varnishes – Determination of resistance to liquids – Part 3: Method using an absorbent medium (ISO ); German version. Buy DIN EN ISO PAINTS AND VARNISHES – DETERMINATION OF RESISTANCE TO LIQUIDS – PART 3: METHOD USING AN ABSORBENT. DIN EN ISO Paints and varnishes – Determination of resistance to liquids – Part 3: Method using an absorbent medium (ISO ).
Pull-off testing ISO Pril added, solid and metallic paint coats using commercially available polish. Variable-loading method ISO If the substrate of the test piece is to be examined for visible alterations, remove the coating in conformity with the specified procedure.
Testing of Resistance
isso Affiliation List of ICS codes. Execution and supervision of paint work ISO Moreover, the test liquid shall not be affected by the test pieces. Option to visualize changes at a glance. It should be agreed whether the reverse side of the panel will be protected with a sufficiently resistant coating, or whether both sides of the panel will to be coated with the coating material under test.
ISO 色漆和清漆 耐液体介质的测定 第1部分：在除水以外的液体中沉浸 – MBA智库文档
The English translation is believed to be accurate. Almandite garnet ISO Adobe is a trademark of Adobe Systems Incorporated.
Dry or stove and age if applicable each coated test panel for the specified lso under specified conditions. If several test pieces are immersed in a vessel, these test pieces shall be identical.
Print-free test ISO Clean off any dried residue of aqueous test liquids under running water, and clean off the dried residue of any other test liquids with a solvent that does not attack the coating. Behavior in pressure washer test acc.
Apply polish with a cellulose pad, let dry and then buff with cotton. Surface-drying test using ballotini ISO Draft International Standards adopted by the technical committees are circulated to the member bodies for voting.
Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO’s member body in the country of the requester.
NOTE 2 Rods are used to eliminate 28812-3 effects. Goniochromatic paints Automotive fuels – Fatty acid methyl esters FAME for diesel engines Requirements and test methods Automotive fuels – Unleaded petrol – Requirements and test methods Paints and varnishes – Determination of stone-chip resistance of coatings – Part 1: Paints and varnishes – Determination of resistance to idn – Part 3: If agreed, compensate for any loss of liquid by adding test liquid or water conforming to the requirements of grade 3 of ISO at specified intervals, in order to keep the initial volume or initial concentration constant.
Get a quote for certification of systems, products or services, and get ein. Initial surface conditions, preparation grades and flash rust grades in connection with high-pressure water jetting ISO The paint shop provides information about the substrate type of plastic material and commercial namechecks the requirements as early as possible this also applies to pre-series parts: Rust izo and preparation grades of uncoated steel substrates and of steel substrates after overall removal of previous coatings ISO Method for the calibration of ISO surface profile comparators and for the determination of surface profile – Focusing microscope procedure ISO The main changes are: Check standard for current issue prior to usage.
If several test pieces are loaded in the vessel 2812–3 the same time, make sure that they are spaced at least 5 mm apart or, in the case of highly conductive test liquids, 30 mm apart see 8. Evaluation after 30 min acc.
General introduction and designation system ISO No part of this document may be transmitted or reproduced without prior permission of a Standards Department of the Volkswagen Group. Super unleaded gasoline acc. Cross-cut testing and X-cut testing ISO Method using an absorbent medium ISO